1590 buckeye drive - milpitas, ca 95035 - tel: 408-432-9898 - fax: 408-432-1551 - components@remec.com - www.remec.com specifications subject to change without notice. specifications subject to change without notice. remec i/q mixer / modulator communications band rf 1.4-2.8 ghz lo 1.4-2.8 ghz if dc-500 mhz lo(ghz) 1.4-2.8 1.4-1.7 1.7-2.8 1.4-2.8 1.4-2.8 1.4-2.8 1.4-2.8 1.4-2.8 1.4-2.8 1.4-2.8 rf(ghz) 1.4-2.8 1.4-1.7 1.7-2.8 1.4-2.8 1.4-2.8 1.4-2.8 1.4-2.8 1.4-2.8 1.4-2.8 if(mhz) dc-500 dc-500 dc-500 dc-500 dc-500 dc-500 dc-500 dc-500 dc-500 min 18 db 20 db 34 db 20 db typical 6.0 db 22 db 30 db 0.2 db 3 deg 42 db 40 db 30 db 45 db +6 dbm +9 dbm +13 dbm +14 dbm +17 dbm +21 dbm +10 dbm +13 dbm +17 dbm max 8.0 db miq24 miq26 miq27 miq24 miq26 miq27 miq24 miq26 miq27 conditions specifications electrical specifications (1) : parameter ssb conversion loss: (2) (3) image rejection side- band suppression: (4) amplitude match phase match isolation lo to rf: lo to i/q: rf to i/q: i/q to rf: input 1-db compression point: input third order intercept point: lo power: (5) miq2 x ms-1 notes: 1. specifications are guaranteed when tested as a downconverter in a 50 ohm system at +25c with the nominal lo power. specifications indicated as typical are not guaranteed. 2. noise figure is typically within 0.5 db of conversion loss for if frequencies greater than 10 mhz. 3. conversion loss typically degrades less than 0.5 db at +100c and improves less than 0.5 db at -55c. conversion loss is the combined value. 4. measured with an if quadrature hybrid whose amplitude and phase errors are 0.5 db and 3 degrees maximum. an if quadrature hybrid is not included. 5. usable lo drives are up to 2 db below to 3 db above nominal. 6. see application notes m112, for aid in selecting the outline and for mounting and installation information. typical performance at 25 c lo power 4 = +10 dbm 6 = +13 dbm 7 = +17 dbm all dimensions are in inches and [mm]. 3-51 outline: ms6 miq2 x ms-1
|